Flame Safeguard & Combustion Controls.

E110 Flame Monitor

The Fireye® E110 FLAME-MONITOR System is a microprocessor based burner management control system designed to provide the proper burner sequencing, ignition and flame monitoring protection on automatically ignited oil, gas, and combination fuel burners. In conjunction with limit and operating controls, it programs the burner/blower motor, ignition and fuel valves to provide for proper and safe burner operation. The control also provides current operating status and lockout information in the event of a safety shutdown.

ED510 Display Module

The ED510 Display Module is designed to operate with the FLAME-MONITOR Burner Management Control System using the EP and EPD style (remote mount only for EPD style) programmer modules. (Note: The EP Programmers must have an Engineering code of 28 or later. The EPD programmers must have an Engineering code of 02 or later. The Engineering code is stamped on the printed circuit board along with the date code. e.g: 9412-28). The ED510 display module provides the following features and capabilities:
· Two (2) line by sixteen (16) character backlit LCD display.
· Continuous display of current burner operating status, including first out annunciation in the event of a lockout condition.
· Three (3) key, tactile dome keypad to provide historical information of the burner, last six (6) lockout conditions (with burner cycle and burner hour time stamp), assign messages associated with the operation of the E300 expansion module, and diagnostic messages.
· Design mounts directly onto the front face of the EP style programmers.
· RJ style connector for connection to the EP and EPD style programmer.
· Remote display capability with the EP and EPD style programmers using standard DIN sized opening and remote mounting kit. Refer to Bulletin ED-8101.

EP160, EP161, EP165, and EP170 Programmer Modules

The EPI60, EPI61, EP165, and EP170 programmers provide start-up programming, safe-start check, and flame monitoring supervision. They insure open damper (high purge) prepurge, proof of low fire position, and fuel valve end switch safety checks. A running interlock circuit on the FLAME-MONITOR system constantly monitors the limit switches, air flow switches, and fuel pressure switches through the programmer. The programmer control is designed to initiate a safety lockout if any of these circuits are open at the improper point in the control cycle.

• For more more information on Fireye flame safeguard and combustion controls please contact us directly or go to http://www.fireye.com.
• To order any parts, you can contact us or send an e-mail request directly to our parts department.